The Ultra-Thin Downlight That Doesn't Need a Frame, a Reflector, or a Deep Ceiling.
All-in-one flat LED design eliminates the traditional housing stack — no frame, no reflector, no 5-inch clearance. At 125 lm/W with dual dimming (0-10V + phase cut) and 5CCT, it drops into shallow ceilings and remodel projects that other downlights can't enter.
No Frame. No Reflector. No Wasted Ceiling Depth.
Traditional downlights need a housing, a reflector, and a trim kit — each adding depth and cost. This all-in-one design eliminates all three, fitting directly into the ceiling with spring clips and nothing else.
Built for Low Plenum and Shallow Ceiling Spaces
If existing ceiling depth rejects standard recessed cans, this fixture was designed for you. The ultra-thin profile slides between joists in remodels where the framing won't accommodate traditional housings.
Dual Dimming — 0-10V for Commercial, Phase Cut for Residential
Compatible with both 0-10V building automation and standard residential phase-cut dimmers. No need to stock separate commercial and residential versions — this one handles both.
125 lm/W Means More Light from Less Power
Industry-leading efficacy for the slim-panel category. Higher efficiency means smaller electrical loads, which matters when you're retrofitting a building with limited panel capacity.
Two Size Options, Three Wattage Steps Each
Available in 4" (6/8/10W) and 6" (8/10/12W) configurations. Adjust wattage on-site to match the actual room requirements — no field returns for over-lit or under-lit spaces.
